3D-printed car shown at Detroit motor show

Local Motors's pioneering car is built using a carbon-reinforced ABS plastic chassis.


The scores of new cars on show at the North American International Auto Show come from factories across the US and around the world, but there's only one that comes right off the show floor.

Local Motors is pioneering a 3D-printing technology in collaboration with Oak Ridge National Laboratory that squeezes carbon-reinforced ABS plastic through an inkjet-like nozzle so, bit-by-bit, an entire car chassis can be created. The carbon fibre gives the plastic a lot more strength.

Once printed, the body is milled and polished so it's smooth and then it's ready for the wheels, electrics and steering and motor to be attached. Local Motors is sourcing those from the Renault Twizy, an electric-powered city car produced by the French automaker.

The process enables prototypes to be created much faster than with traditional fabrication technologies and is cheaper for small runs, Local Motors said.

The Arizona-based company hopes to begin commercial production of cars this year and is building micro-factories in Knoxville, Tennessee and in National Harbor, which is near Washington DC.


The company's Strati concept took about 44 hours to be printed and consists of about 500kg of plastic, which costs about £1.50 per kilogram.

In a test ride at the Detroit Motor Show of a car printed before the show began, the Strati proved to have quick acceleration. The track was too small for the car to get up to its top speed of 44 miles per hour, but it certainly seemed capable of the task. The plastic body appeared sturdy and didn't show any obvious signs of flexing or weakness.

Advertisement. Article continues below

The car's battery has a range of between 40 miles and 60 miles depending on the driving conditions.

Before the cars hit the street, they will have to pass safety crash tests.